Bulkhead kit - 1/2"

Weldless bulkhead with adaptable gaskets for fitting a spigot into a brewing kettle. Drill a hole in the kettle and screw the bulkhead into the kettle and attach the spigot. On the inside, the extended threaded section allows other items to be fitted. Tips: Fit the threaded section and washer on the outside of the kettle and the O-ring and nut on the inside. Tighten the nut with the cut-out against the O-ring on the threaded section. Tighten it so that the O-ring is no longer visible. Ideally, you should mount the bulkhead when slightly wet. easy to mount 1/2" BSPT fitting for the spigot all stainless steel construction there is sufficient thread on the inside of the kettle to add other accessories silicone O-ring wrench width 24 and 32 mm ACCESSORIES